I have an Inoo3d RTX 2060 Super Ichill X3 Ultra.

Tried two times to paste it and failed.

One time MX6 failed cause it was thick and difficult to work with, temps from 83c, hot spot 98c to 75c temps, 90c hotpsot.

This time i tried Mastgel Pro V2, was easier to work with, still failed, from 83c temps, 105C hotspot to 76c temps, 90c hotspot.

Vram is 81C.

Without side panel temps are 71c, case has 3 intake fans and one exhaust fan, room temp is 18 to 23c

I wanted the temps to be 65c and hotspot 78c with side panel closed (cause I don't want dust)

The GPU is in stock settings, no overclocking or undervolting.

It should achieve 65c easy and without undervolting, it's only a 180w GPU with a massive heatsink and 3 fans.

I used the original pads cause they were in good condition, and i can't procure the correct pad size so it's better not to risk it with new pads.

Cleaned with %99 ethanol.

I tried the manual spreading (mx6) and 5 dots method (prov2)

I put the pcb on the heatsink (cause that's the side where the 4 spring screws are) down in one go and tightened in criss cross pattern.

Cleaned the fan shrouds and everything.

What am i doing wrong?