I just realized that I placed this part upside-down right before I was going to sand off some sprue goo that was sealing it in place…

pla 0 1

I just realized that I placed this part upside-down right before I was…

I just realized that I placed this part upside-down right before I was going to sand off some sprue goo that was sealing it in place…

Is it possible to remove, and re-place this part without damaging it or the plane?

submitted by /u/Spino2425 to r/modelmakers
[link] [comments]

이 글을 SNS로 공유하기